Work from a metal buttons manufacturer Thailand garment factories can reorder from is judged at the edges — where the component meets the cloth, and where the coating has to hold its thickness across a curve. Three pieces are shown close here: a four-hole sewing button seated on a workwear placket, a low-domed leather rivet in a matte pale grey-green, and a jeans button seen from underneath, ringed by a rolled rim. Rim geometry and proportions are drawn in CAD/CAM and proved as 3D-printed prototypes before the die is cut, head shapes and patterns can follow a customer’s own drawing under OEM, and every piece is inspected in-house before despatch, with surfaces checked under a microscope.
A Wide Flat Rim on a Sewing Button

A wide, flat rim rounds off towards the cloth, so the button sits close to the placket rather than standing above it.
Charcoal thread sits in the recessed centre and reads only faintly against the satin silver tone, keeping every face along the row consistent.
A Sewing Button is fixed with thread on the normal sewing line — well suited to uniform and workwear production. We would be glad to discuss your requirements.
See our sewing buttons range →
An Even Coating From Crown to Rim

A low-domed Leather Rivet, matte in a pale grey-green tone. The highlight across the crown is one continuous band, unbroken from side to side.
A compound curve is where coating thickness tends to drift — thin at the crown, or pooled along the lower edge. An even sheen from crown to rim is the result of a film laid down uniformly across the whole piece.
Every piece is inspected in-house 100% before despatch, with surfaces checked under a microscope.
See our leather rivets range →
The Rolled Rim Beneath a Jeans Button

Seen from underneath, this jeans button is ringed by a rolled outer rim in a deep navy tone, enclosing a brighter, finely brushed face.
Rounded rather than cut square, the rim keeps the contact line continuous and free of sharp edges, sitting flat against the cloth once the button is set at the waistband.
Rim geometry and proportions are drawn in CAD/CAM and proved as a 3D printing prototype before the die is cut.
Images are for presentation; the colour and finish of actual pieces may differ. Please confirm specifications with us before production.
For samples, OEM designs or a quotation, call +66-2-4510794 or send us a message through our contact form.

