A trouser hook manufacturer is judged on how a part behaves once it is set into cloth, not on how it looks in the palm. This article reads three components at close range: a trouser hook lying flat along a waistband seam with its spine upright and two tapered prongs holding in the fabric, an eyelet shown from the side, the top and the inner wall so the rolled rim can be followed right around, and a jeans rivet whose shallow four-sided pyramid head sits on a square base with softly rounded corners. Form and finish are both set by the tooling — drawn in CAD/CAM, prototyped by 3D printing, then cut as job-specific high-precision stamping dies — and shapes or logos can follow a customer’s own drawing under OEM, with every piece inspected in-house before dispatch.

A Trouser Hook on the Waistband Seam

A single silver-toned metal trouser hook resting on dark charcoal grey woven fabric beside a stitched waistband seam, its flat spine standing upright and two tapered pointed prongs angled down into the cloth, against a dark background.

Set flat along the waistband seam, the upright spine takes the pull of the closure while two tapered prongs hold firmly in the cloth.

The load spreads along the band rather than at a single point, so the waistband stays flat with no ridge under a jacket.

Hook components are produced to customer drawings on an OEM basis. We would be pleased to discuss your requirements.

See our trouser hooks range →

One Eyelet, Seen From Three Sides

Three bright mirror-silver eyelets on a dark grey textured stone surface: one lying on its side showing the open barrel, one standing upright behind it with its flange flat on the surface, and one face up in front showing a rolled rim around a clear round bore.

Side, top and inner wall in one frame: the rolled rim runs unbroken around the circle, the reflective surface stays even, and no seam shows along it.

Flange and barrel must share a single centre — that is what keeps the bore round and the rolled edge pressing evenly onto fabric.

Each form is prototyped by 3D printing before a job-specific high-precision stamping die is cut.

See our eyelets range →

A Pyramid Head on a Square Base

A single mirror-bright silver-toned jeans rivet head on a dark grey surface, formed as a shallow four-sided pyramid on a square base with softly rounded corners, each flat facet running up to a central apex.

The rivet head is a shallow four-sided pyramid on a square base with softly rounded corners. Each flat facet runs up to a single apex, so the silver-toned surface reads differently from every angle.

Used at stress points on denim pockets and similar garments. Head shapes and logos can be made to the customer’s own design (OEM) using CAD/CAM.

Every piece is inspected in-house before dispatch. We would be pleased to discuss your requirements.

See our jeans rivets range →

Images are for presentation; the colour and finish of actual pieces may differ. Please confirm specifications with us before production.

For samples, OEM designs or a quotation, call +66-2-4510794 or send us a message through our contact form.